Thanks aepos. I built a very simple geometry that consists of 3 cylinders, one is a straight cylinder, the second starts from the top of the first and is an oblique cylinder, the third is also oblique and is inserted inside the end of the second.
The model runs but when I look at the results in paraview I see the first two cylinders both straight and the third, which would be a fluid, outside the structure, so it does not flow inside the first two. DualSphysics doesn't give me messages that can explain this behavior
Any idea about?
Thanks aepos. I built a very simple geometry that consists of 3 cylinders, one is a straight cylinder, the second starts from the top of the first and is an oblique cylinder, the third is also oblique and is inserted inside the end of the second. The model runs but when I look at the results in paraview I see the first two cylinders both straight and the third, which would be a fluid, outside the structure, so it does not flow inside the first two. DualSphysics doesn't give me messages that can explain this behavior Any idea about?