Everything Presence Zone Configurator not correctly updating position.

[superiormirage]

I have two Everything Presence Lite that are exhibiting the same behavior. When I try and use the Zone configurator add-on for home assistant, my position isn't updating correctly on the radar map.

No matter where I move, the red dot always stays in the center of the radar, right in front of the sensor.

I believe the Lite is updating my position correctly, but it's not showing up on the visual radar.

I was in the same spot as the screenshot above.

[EverythingSmartHome]

This is because the units of measurement have been changed from the default of mm to inches. The zone configurator expects mm (default for the Lite)

[packetwarrior]

Maybe I'm a little dense here, but I keep seeing this answer everywhere, but no details about how to change it back to metric. We aren't talking about changing the 'Unit system' in Home Assistant's system setting are we? Can't find any similar setting anywhere else. I just bought a few more sensors, so I'm hoping that's not the case.

[billyjoebob999]

Maybe I'm a little dense here, but I keep seeing this answer everywhere, but no details about how to change it back to metric. We aren't talking about changing the 'Unit system' in Home Assistant's system setting are we? Can't find any similar setting anywhere else. I just bought a few more sensors, so I'm hoping that's not the case.

Having the same problem. To change the unit of measurement I just clicked the the sensor. Click the gear icon and change the unit of measurement from in to mm

Did this for each sensor