I have a Zebra GC420t printer. I installed the GC420t (EPL) driver from Zebra Utilities. I've set the driver preferences on the Options tab as follows.
Settings: Darkness 15
Paper format: inch, portrait, and Rotate 180 degrees
Size: W: 1.00 & H: 2.00
I installed SpineOMatic as recommended. I set the Printer Setup to point at the GC420t (EPL) printer, text font is Verdana 11.25 bold.
I can print two spine labels, but after the second one the printer advances a length of label between four and six inches and the power button on the printer flashes red.
I've tried several different printer drivers with no success. Any suggestions would be greatly appreciated.
I have a Zebra GC420t printer. I installed the GC420t (EPL) driver from Zebra Utilities. I've set the driver preferences on the Options tab as follows. Settings: Darkness 15 Paper format: inch, portrait, and Rotate 180 degrees Size: W: 1.00 & H: 2.00
I installed SpineOMatic as recommended. I set the Printer Setup to point at the GC420t (EPL) printer, text font is Verdana 11.25 bold.
I can print two spine labels, but after the second one the printer advances a length of label between four and six inches and the power button on the printer flashes red.
I've tried several different printer drivers with no success. Any suggestions would be greatly appreciated.