search

SchmockLord / Hackintosh-Intel-i9-10900k-Gigabyte-Z490-Vision-D

https://www.patreon.com/SchmockLord
https://youtu.be/szOofRy7uBc
686 stars 125 forks source link

Intel I225-V issues: cable unplugged (Asus Prime Z490-A hackintosh) #151

Open nicoquintana98 opened 3 years ago

nicoquintana98 commented 3 years ago

Hello. I need help with a problem with my ethernet port. I have an Asus Prime Z490-A motherboard with an I9 10850K processor. I have Big Sur 11.2.3 and windows installed. They both boot perfectly. I have followed all the steps, recommendations and troubleshooting of this post and many others and I can't get the ethernet to work. I have already installed the fakepciide´s kext (I have tried different versions), I have verified the path of my ethernet with IO explorer and also with hackintool and I have placed it in my config.plist. The best I have done is for macos to detect the ethernet and identify it as i225-LM. All this verified in "system report" but in the network configuration it tells me that the cable is disconnected (I clarify that in windows it works perfectly) I leave a list of other things that I have tried:

EFI of other users, unmodified, boot perfectly but the ethernet problem persists. Install from recovery Catalina and Bigsur, neither takes internet. I leave images and my settings in case they help. I really need help, I have been with this problem for more than a week. Thanks a lot. https://drive.google.com/drive/folders/1OHyYVYvxtzcH_DQEEoNNwATrnwWwkRTq?usp=sharing

HARDWARE

Asus Prime Z490-A Intel i9-8500K 32GB DDR4 3200MHZ (xpg spectrix d80) XPG Gammix S11 Pro 1TB M.2 NVMe SSD Intel UHD Graphics 630 (Primary) Intel® I225-V 2.5Gb Ethernet SMBIOS: iMac20,1

SchmockLord commented 3 years ago

Try the following: Delete the AAPL,slot-name entry in your device properties, they look false to me.

And when you see the Ethernet adapter in network, go to the settings, then hardware and change configure to manual and speed to 2500Base-T or 1000, depending on what you have behind it.

Also, I noticed that you are using USBInjectAll.kext and a USBPorts.kext. You should only use either. I have removed USBInjectAll.kext. And your iGPU device Properties had a minus 1 at the end, removed it.

And because I have a good day and it was easy, I cleaned up your config a bit.

EFI_after Schmocklords Magic.zip

You should be able to use this one as it is. No changes.

nicoquintana98 commented 3 years ago

I SOLVED IT !! Thank you SchmockLord for your advice. I'm going to review what you sent me. The problem was fixed by replacing the ethernet cable. This one had only 4 cables inside, enough for windows to work but not for Macos ... I used another cable with all 4 pairs of cables and it worked perfectly. I hope someone will find my experience useful.