When Rampage is set as follows the output rises to 9.451 volts then stops and the channel remains in the rise phase until the range is changed or the shape/rise time are reduced:
Max rise time, fall time doesn’t matter
Longest range
Shape fully CW
All other controls set to default values
nothing connected to the input
To reproduce the issue, set a channel up as outlined above and manually trigger it.
Note that once the channel has stopped at 9.451 volts, adjusting the shape slightly allows the it to continue but, depending on the new shape setting, it stops again at a higher voltage. In the example below, the shape was adjusted to 0.9:
Issue discovered on Windows 10 and confirmed on Kubuntu Linux (here).
When Rampage is set as follows the output rises to 9.451 volts then stops and the channel remains in the rise phase until the range is changed or the shape/rise time are reduced:
To reproduce the issue, set a channel up as outlined above and manually trigger it.
Note that once the channel has stopped at 9.451 volts, adjusting the shape slightly allows the it to continue but, depending on the new shape setting, it stops again at a higher voltage. In the example below, the shape was adjusted to 0.9:
Issue discovered on Windows 10 and confirmed on Kubuntu Linux (here).