Closed nemgrea closed 1 year ago
Just to make sure I understand: are you saying that a V0.2 typically doesn't need any adjustment of the 0,0 location?
Just to make sure I understand: are you saying that a V0.2 typically doesn't need any adjustment of the 0,0 location?
adjusting the bed location is not possible in the same way as the other printers so moving to the corner of the bed and asking fo position causes issues for people when what they should be doing is homing to 120,120 and then verifying that they can reach 0,0 without crashing into the frame.
the edge of the bed stuff causes people to get stuck and start modifying their position_endstop
values
i think the verifying 0,0 location section just needs slightly different instructions for the v0 compared to the other printers, i dont have anything like that written yet though.
i think with sensorless homing we will see less people with 117-119 max travel that requires adjustments from the config..
we can leave it in until a new paragraph is written, im good either way on that
no, fair enough. if the current instructions are doing more harm than good, better to have nothing until you get something written
v0.2r1 updates