This repository contains code and data for testing the compliance of Automated Frequency Coordinator (AFC) software. The AFC is defined by the FCC in proceeding 18-295 on Unlicensed Use of the 6 GHz Band. This repository contains procedures, documentation, and tests for such software, and for the devices authorized by it. To contribute, please first read the CONTRIBUTING file in the repository for instructions.
14
stars
3
forks
source link
Billboard Reflector Path Segment Gain Calculation clarification #60
In Section 'R2-AIP-31 Interference Analysis involving Passive Sites' it is mentioned (about page 55
ii. The AFC System shall determine the effective path Segment gain of the Virtual Receiver, GPathSeg, as follows:
...
2. Single passive reflector:
...
DRx, Next: Diameter (meters) of the antenna at the next site towards the actual FS receiver, where the diameter is the back-to-back receive antenna diameter if the next site towards the actual FS receiver is a back-to-back repeater.
But for a single passive reflector this above sentence seems wrong as it is taking about back to back receive diameter
diameter is the back-to-back receive antenna diameter
For a single reflector what should be the value of DRx, Next be ?
As per WINNF-TS-1014 V 1.14
In Section 'R2-AIP-31 Interference Analysis involving Passive Sites' it is mentioned (about page 55
But for a single passive reflector this above sentence seems wrong as it is taking about back to back receive diameter
diameter is the back-to-back receive antenna diameterFor a single reflector what should be the value of
DRx, Nextbe ?