search

acd / infinitive

Infinitive impersonates a SAM on a Carrier Infinity system management bus
MIT License
100 stars 39 forks source link

Multinozne config #13

Open fork04 opened 6 years ago

fork04 commented 6 years ago

Hello, i want to be guinea pig. My setup is Blower, humidifier and 2 zones. I have Carierr Infinity connected to rpi3.

gdgeist commented 6 years ago

Similarly looking to give it a shot with 3 zones and Bryant (my HVAC guy says they just put a different sticker on at the parts supply for most of the Carrier/Bryant)

gdgeist commented 6 years ago

@acd or @Will1604 - I have this running on a three zone system, gas fired furnace, variable speed fan, ac and humdifier. Looks like Zone 1 displays properly (it displays the actual temperature in the room without the thermostat configured offset of 2 degrees). What would you need to be able to be effective in the other zones? I see the code is easily extended (thanks for building the dictionary in up front) I can turn off the program and just dump the raw rs485 tty connection into a file and post or?

mikerolica commented 4 years ago

I have an 8 zone system, using the Keeprite/tempstar ion control. ( is the same as the bryant/ carrier.

c-miceli commented 6 months ago

@acd or @Will1604 - I have this running on a three zone system, gas fired furnace, variable speed fan, ac and humdifier. Looks like Zone 1 displays properly (it displays the actual temperature in the room without the thermostat configured offset of 2 degrees). What would you need to be able to be effective in the other zones? I see the code is easily extended (thanks for building the dictionary in up front) I can turn off the program and just dump the raw rs485 tty connection into a file and post or?

sorry to jump in but did you get this to work? My best friend just bought a house with a 3 zone system and i am stumped. I can get control of zone 1 but i can't figure out 2 and 3. Thanks