Add board 'sparkfun_nrf52840_micromod'.

[nitz]

Hey there!

Added the SparkFun MicroMod nRF52840. Opening the PR as a draft, because I don't have a PID to use. Gonna try to get in touch with someone from SparkFun and see if they've got some PIDs they'd like to use for UF2 & CircuitPython.

Hope you're well!

[cdwilson]

FYI, here's the link to the SparkFun forum post for those following along:

https://forum.sparkfun.com/viewtopic.php?f=182&t=55251&p=223742&hilit=nrf52840+bootloader

[nitz]

FYI, here's the link to the SparkFun forum post for those following along:

https://forum.sparkfun.com/viewtopic.php?f=182&t=55251&p=223742&hilit=nrf52840+bootloader

Thanks for posting the link! I went to bed right after I posted it last night and it seems that posts (or at least from newer accounts) needed to be manually approved. 🙂

[nitz]

Thanks, Thatch!

Done! I didn't realize that, but makes total sense.

Are you okay with the volume label, too? I felt like I was trying to cram as much info into as few characters as possible, but perhaps crammed too much 😂

[hathach]

Thanks, Thatch!

Done! I didn't realize that, but makes total sense.

Are you okay with the volume label, too? I felt like I was trying to cram as much info into as few characters as possible, but perhaps crammed too much

to be honest, I don't use these boards, so I wouldn't care that much. Anything that makes sense is good enough.

[nitz]

Thank you! I will send a note to some sparkfun folx asking if the v10/v11/v12 are supposed to be "dot one", "dot two", etc. just in case!

[hathach]

no problem, this is already merged, feel free to make follow up PR for correction later if needed.