D80 not working with v0.7.186

[GoogleCodeExporter]

What steps will reproduce the problem?
1. Install NCC v0.7.186
2. Connect D80
3. Take picture

What is the expected output? What do you see instead?
Instead of saving and displaying the file there is no response at all. If I try 
to take another action, it says "Camera is busy" or something like this.

What version of the product are you using? On what operating system?
NCC v0.7.186 and Vista.

Please provide any additional information below.
With v0.7.165 and the same setup it works fine.

Original issue reported on code.google.com by dove...@gmail.com on 14 Aug 2012 at 4:51

• Merged into: #29

[GoogleCodeExporter]

I'm getting the same issue with version 7.209. After taking a photo with the 
Nikon d80 it says Device MTP error: Device is busy. 

Original comment by jabarnes...@gtempaccount.com on 27 Aug 2012 at 6:18

[GoogleCodeExporter]

This problem it is caused by SDRam option, i remove this option in next version 
for D8/D60/D40 cameras, if i figure out what cause this problem i will enable 
again.

Original comment by Duk...@gmail.com on 7 Sep 2012 at 6:44

• Changed state: Accepted

[GoogleCodeExporter]

Original comment by Duk...@gmail.com on 5 Dec 2012 at 2:11

• Changed state: Duplicate