search

alexqzd / Marlin

Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. | Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine.
http://marlinfw.org
GNU General Public License v3.0
197 stars 71 forks source link

Pause to Print return to Z-axis too high #35

Open kyledurieux opened 2 years ago

kyledurieux commented 2 years ago

Using a Voxelab Aquila S2, I set the pause to print to stop so that I could change the filament. (This issue also occurred with the change filament plugin as well). Machine paused at 14mm and then moved to park position at 15mm on the z axis. Fine. Then once the pause was complete the machine returned to print higher than the last printing position, about 1mm higher.

I read through a few blogs on the issue, here is one: (https://github.com/Ultimaker/Cura/issues/5924). I am hoping that the issue can be rectified soon by Cura? Or, someone with the technical know how to fix the error. Right now I am manually changing the g-code to fix the issue.

classicrocker883 commented 2 years ago

how about redo last layer? there's an option for that, no?

kyledurieux commented 1 year ago

There is an option there for that yes but why would I choose that option…? I admit I did not try that option yet because it didn’t seem relevant to use that option, but I will try it.

From: Andrew @.> Sent: Thursday, October 6, 2022 2:00 PM To: alexqzd/Marlin @.> Cc: kyledurieux @.>; Author @.> Subject: Re: [alexqzd/Marlin] Pause to Print return to Z-axis too high (Issue #35)

how about redo last layer? there's an option for that, no?

— Reply to this email directly, view it on GitHub https://github.com/alexqzd/Marlin/issues/35#issuecomment-1270611350 , or unsubscribe https://github.com/notifications/unsubscribe-auth/A3IFXJQDM33RDWPDROFQPW3WB4VTVANCNFSM6AAAAAAQU3DXOM . You are receiving this because you authored the thread.Message ID: @.***>