search

bigtreetech / BIQU-B1

147 stars 105 forks source link

bltouch #53

Open Sheller19 opened 8 months ago

Sheller19 commented 8 months ago

I bought a bltouch, but it does not calibrate correctly, since there is a large gap from the nozzle to the table ! Where and how can this be changed?! Or do I need to flash it?

Mategm commented 8 months ago

Hello Sheller19! I also bought a bltouch, and i tried to use it, but after the long hours of suffering, I left it. Rather then I use manual leveling, because it's have points to it, so it's little bit easier than an Ender printer.