search

bigtreetech / PandaTouch

94 stars 6 forks source link

Printer Connection Failed #57

Closed jonjmills closed 2 months ago

jonjmills commented 2 months ago

Brand New Unit setup. Connected to same WIFI/Network as printer.

Scan for Printers produces 0 results. Manual setup of printer ends in Failed to connect.

Printer Firmware: 01.05.02.00 Cloud mode Panda Touch Firmware: 1.0.1

Unfi Network and AP points.

Any suggestions to test?

bigtreetech commented 2 months ago

Very likely that your network is blocking intra device to device comms. This is the case with many "guest" type networks. There is often a setting on the router to enable comms between devices on your network.

jonjmills commented 2 months ago

Did some more troubleshooting on this and there is def something on myside blocking.

Created new network and WIFI SSID and everything connected and worked without issue. Tried again on the original network/SSID with all firewall rules turned off and settings matched to the new network/SSID, still no go.

I am at a loss on what could be blocking but its not the device, closing the issue.

bigtreetech commented 2 months ago

Glad to hear that it came right.

bigtreetech commented 2 months ago

Did some more troubleshooting on this and there is def something on myside blocking.

Created new network and WIFI SSID and everything connected and worked without issue. Tried again on the original network/SSID with all firewall rules turned off and settings matched to the new network/SSID, still no go.

I am at a loss on what could be blocking but its not the device, closing the issue.

BTW, firewall rules apply to data coming in from WAN and going out to WAN but not intra. There will be a separate setting for that.