search

danielkucera / esp-arduino-ebus

78 stars 11 forks source link

How to reset 5.1 HW #41

Closed tomklapka closed 9 months ago

tomklapka commented 1 year ago

can't connect TX-DISABLE (previously ESP-RX) and GND pins using a wire - there is no pin marked TX-DISABLE anymore.

danielkucera commented 1 year ago

Hello, this is a bug. I am preparing a fix in #43 but it is not ready yet. To reset the device config with current firmware, please disable your wifi temporarily so the device cannot connect. After this the config AP will appear and you can reset the config from there.

tomklapka commented 1 year ago

It's totally fine. Thank you for the great work on this. My previous esp8266 v3.1 died for some reason, but the new c3 5.1 seems to be very stable and responsive, I hope it will last longer :).

danielkucera commented 1 year ago

I am sorry to hear that. Would you mind sending it back for analyzing the problem? I can give you a refund for the new one.

tomklapka commented 1 year ago

It's ok, I've already done some desoldering attempts which compromised the further usability :)

danielkucera commented 1 year ago

I am not going to use it, just to find the root cause.