search

donnelbn / catgenius

Automatically exported from code.google.com/p/catgenius
0 stars 0 forks source link

Is project alive ? #5

Open GoogleCodeExporter opened 8 years ago

GoogleCodeExporter commented 8 years ago 
Just wanted to ask 

a) Is the project is alive & fairly supported ?

b) Are new versions of CatGenie (purchased within 2014) can still work OK with 
CatGenius ?

Original issue reported on code.google.com by agelos.p...@gmail.com on 2 Apr 2014 at 3:35

GoogleCodeExporter commented 8 years ago 
I have the same 2 questions, also are any Catgenius available for purchase?

thanks

Original comment by lrhmil...@gmail.com on 7 Apr 2014 at 3:25

GoogleCodeExporter commented 8 years ago 
[deleted comment]
GoogleCodeExporter commented 8 years ago 
To answer question b above, I imagine it does. I had to have my CG120 processor 
replaced because the arm motor stopped working. They sent a refurbished 
processor, but sabotaged the programming header by partially melting it with a 
soldering iron. I'm not sure if they flashed new firmware or changed anything 
on the board, but I was able to solder new headers and flash it just fine.

Original comment by cmack...@gmail.com on 7 Sep 2014 at 3:19

GoogleCodeExporter commented 8 years ago 
I flashed my 120 with CatGenius Beta release B04 for PIC16F877A. Everything is 
fine until the rinse cycle starts. WATER DOESN'T SHUT OFF unless I unplug the 
PU then plug it back in, only then does it turn the water off and start the 
drain cycle. I had water all over the floor after work. Now I only run the 
cycle when I get home to babysit the unit. I am going to try to reflash to an 
earlier HEX ??? I haven't been able to post anywhere but here. Please help.

Original comment by letsgofl...@gmail.com on 20 Dec 2014 at 1:54

GoogleCodeExporter commented 8 years ago 
So I can verify that the Beta release B04 works on PIC16F1939 for a unit 
purchased in the beginning of 2014.

Original comment by DTA...@gmail.com on 24 May 2015 at 2:27