search

espressif / esp-csi

Applications based on Wi-Fi CSI (Channel state information), such as indoor positioning, human detection
Apache License 2.0
706 stars 111 forks source link

How to use router to send CSI data (AEGHB-568) #165

Open 2heYu110 opened 8 months ago

2heYu110 commented 8 months ago

Good day. I am using ESP32 as my receiver and I would like to use D-Link AX3000 router to send CSI data. I have done 3.2 Receive Wi-Fi CSI to my ESP32 and I am able to open the CSI visualization interface. Can I know how to setup the router to send CSI data? Meanwhile, what does the phase "The router is not connected to other intelligent devices" means? Thank you.

zhanzhaocheng commented 8 months ago

You only need to refer to this to the router to receive CSI data, without modifying any configuration of the router

2heYu110 commented 8 months ago

Is this the correct way to use the ESP CSI Tool? After I entered the ssid and password in the router connection window, there aren't anything shown in the "log print window" and the "CSI data waveform display window".

image

image

1dot6 commented 8 months ago

Is this the correct way to use the ESP CSI Tool? After I entered the ssid and password in the router connection window, there aren't anything shown in the "log print window" and the "CSI data waveform display window".

image

image

Did you figure it out? I am facing the same issue.

rav2n-dev commented 7 months ago

The same here. No response on the gui or the console