Models made entirely out of support.

eugr / Flashforge-for-Cura

FlashForge Creator Pro profile for Cura 4.4+

90 stars 22 forks source link

Models made entirely out of support. #16

Open CptKekflip opened 3 years ago

CptKekflip commented 3 years ago

After following the installation steps, I've run into the problem of my models being made completely out of the support filament. I've set the left extruder (PLA) as the active one, and designated the support to use the right extruder (PVA), but the slice just makes the entire thing using the right extruder. Has anyone been able to successfully print using both PLA and PVA?

shiruken1 commented 3 years ago

@CptKekflip how did you set one as active? I only get a dropdown to select Left Extruder / Right Extruder for "Support Extruder"

Nonetheless, I'm also getting only one extruder being used. The second one is used only for the raft, then everything else goes to the other one