search

f0cal / google-coral

Community gathering point for Google Coral dev board and dongle knowledge.
107 stars 14 forks source link

Error while flashing leading to unresponsive board #72

Closed AliRSajun closed 4 years ago

AliRSajun commented 4 years ago

I was flashing the dev board according to the instructions on the coral website when it got stuck for a while with the terminal saying waiting for device to reboot. After leaving it for 10 minutes with no movement I disconnected it to attempt to start installation again but now when I try to install it, it gets stuck at the screen step.. it shows a blank screen with no U-Boot prompt at all.

When I try the tutorial for reflashing the dev board I get stuck at the mdt devices command which doesn't show any device. What can I do to bring it back to factory defaults or get it to run again?

zerocool95 commented 4 years ago

I had the same problem on mac os. It worked after a system(macbook) restart. Not sure what the root cause was.

AliRSajun commented 4 years ago

I tried everything to get the U-Boot prompt to show up on screen or to make the board appear on mdt.. nothing worked. Finally what worked was following the tutorial section which showed a way to boot it using the mirco SD card.