rjefferis
commented
2 months ago worked out i could connect to the serial port to try and see what it was doing, not much more info, but I can see it disconnect on there, it shows PTP socket disconnected (state 257) as per below. Thanks
(72) ledc: freq_hz=0 duty_resolution=13 [ 81][E][esp32-hal-ledc.c:75] ledcSetup(): ledc setup failed! E (75) ledc: ledc_get_duty(745): LEDC is not initialized
WiFi AP Name: DIRECT-WGU1:ILCE-7CM2 PTP socket disconnected (state 257) PTP socket stopping due to disconnection
Hi, I have been testing this with 2 of my Sony cameras. ZV-E1 running latest 2.x firmware seems to work fine A7Cii (A7CM2) running latest 1.02 firmware connects initially and is able to trigger the shutter remotely, but is obviously struggling. Interface is laggy and the remote disconnects after roughly 10 seconds of the last action sent to camera. Eg if no remote shutter action is sent the remote will disconnect from the remote PC control after roughly 10 seconds. I have also noticed that even whilst connected the remote is not able to pull any of the camera stats for the display that shows things like shutter speed.
I see mention of enabling logging in a previous ticket, I haven't found how to do that yet.
Thanks