On the UI the GFI operation remains stuck to the initial results and every subsequent request is not executed, when clicking on another point on the map to identify the results remain the same as the first request.
[!NOTE]
The scenario is reproducible only when the one of request ends up in error
How to reproduce
Open a geostory
Make sure multiple layers are present with identify enabled
Perform GFI by clicking on the map
If one of the request fails, then any subsequent GFI calls are not fired instead previous results are only shown
Current Result
The result of the GFI operation remains the same and there is an error on the response
Expected Result
The result of the GFI operation should change according to the area
Description
On the UI the GFI operation remains stuck to the initial results and every subsequent request is not executed, when clicking on another point on the map to identify the results remain the same as the first request.
How to reproduce
Current Result
The result of the GFI operation remains the same and there is an error on the response
Expected Result
The result of the GFI operation should change according to the area