search

gnea / grbl

An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Arduino
https://github.com/gnea/grbl/wiki
Other
4.1k stars 1.61k forks source link

CronosMaker not reacting to XLoader #1255

Open Glasairman opened 4 months ago

Glasairman commented 4 months ago

I wanted to upgrade an old board to grbl 1.1 but getting no reaction. My XLoader settings (frontman for avrdude) are ATMega328/COM4/57600 , no reaction so I suspect the Bootloader is defective. I cannot see any USBAsp port anywhere (I have an AVR Programmer)

Any advice?

lalo-uy commented 4 months ago

If you export compiled binary in Arduino IDE , the .bin and .hex, with and without bootloader are left in the script folder. Just use the standar soft you have with that avr programmer. Dont forget to set the fuses.

El El sáb, 13 jul. 2024 a la(s) 07:03, Glasairman @.***> escribió:

I wanted to upgrade an old board to grbl 1.1 but getting no reaction. My XLoader settings (frontman for avrdude) are ATMega328/COM4/57600 , no reaction so I suspect the Bootloader is defective. I cannot see any USBAsp port anywhere (I have an AVR Programmer)

Any advice?

— Reply to this email directly, view it on GitHub https://github.com/gnea/grbl/issues/1255, or unsubscribe https://github.com/notifications/unsubscribe-auth/ACXBW4JTPKEUVVVJB3O6BB3ZMD3PBAVCNFSM6AAAAABK2EQ5A6VHI2DSMVQWIX3LMV43ASLTON2WKOZSGQYDMOBSHEYTSMA . You are receiving this because you are subscribed to this thread.Message ID: @.***>