finish pcb design

[leomcelroy]

We want to order some new test board by the end of May 2022.

These are the components we know are on the board.

• Raspberry Pi Pico with integrated charging circuit
• LiPo battery
• 6 tactile buttons
• ST7735 TFT 1.8" Screen
• Slide switch
• Some sort of speaker
  • Magnetic Buzzer or
  • Adafruit I2S 3W Class D Amplifier Breakout - MAX98357A
  • Mini Metal Speaker w/ Wires - 8 ohm 0.5W PID: 1890
• 2 Leds
• Some capacitors for noise reduction

we also want to make the board extensible and should add some female header pins to unused pins on the pico, power, and ground

• add extensible female header pins

[leomcelroy]

I'd love some assistance finishing up the KiCad designs. Would @Hugoyhu or @bykevinyang be interested in helping out with this?

[Hugoyhu]

Yeah! I can use KiCAD. Do you want to finish the audio first, or just design the PCB with it?

Sent from my iPhone

On May 18, 2022, at 3:17 PM, leomcelroy @.***> wrote:



I'd love some assistance finishing up the KiCad designs. Would @Hugoyhuhttps://github.com/Hugoyhu or @bykevinyanghttps://github.com/bykevinyang be interested in helping out with this?

— Reply to this email directly, view it on GitHubhttps://github.com/hackclub/gamelab-beaker/issues/2#issuecomment-1130411140, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AQOQDMBI6TNAZC6IJHD47G3VKU63XANCNFSM5WJN7BWQ. You are receiving this because you were mentioned.Message ID: @.***>

[leomcelroy]

I would just design the PCB with it.

[Hugoyhu]

Roger. Design in with theoretical software support then

Sent from my iPhone

On May 18, 2022, at 6:55 PM, leomcelroy @.***> wrote:



I would just design the PCB with it.

— Reply to this email directly, view it on GitHubhttps://github.com/hackclub/gamelab-beaker/issues/2#issuecomment-1130675546, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AQOQDMAKPFZL77PLLCU6AP3VKVYMHANCNFSM5WJN7BWQ. You are receiving this because you were mentioned.Message ID: @.***>