b14ckyy
commented
3 months ago Please set the airspeed sensor up completely, make sure its connected. Then go to the Sensors tab and enable the airspeed sensor. Run a tethered logging into a text file for at least 1 minute and then please post it here.
if the runtime calibration does not complete it could mean a very noisy sensor. Also please check this video from Darren, it might be related as it especially affects SpeedyBee Wing FCs the most https://youtu.be/rEzWCJsS6Nc
Current Behavior
No airspeed output in sensors. Unable to arm 'sensors calibrating'. Seems to work fine in 6.1.
Expected behavior
airspeed to work and not prevent arming
Suggested solution(s)
I see reports that airspeed was broken in inav 6 and fixed in inav 7. This is the opposite for me and I assume this is because i'm using an analog sensor and not digital?? sensor is mpvx7002. I see there are a lot of changes with airspeed and I haven't had time to have a good look into the code but i'd love to contribute in the future
Additional context
https://pastebin.com/XU7S1S8h
INAV/SPEEDYBEEF405WING 7.1.2 Jun 1 2024 / 00:47:23 (4e1e59eb)
GCC-10.3.1 20210824 (release)