Garbled Panel 2

[GoogleCodeExporter]

Panel 2 is broken and results in a garbled display with Arducam v2.0.

I expected to see just items I checked in the tool: speedometer, variometer, 
home arrow, and coords on panel 2. Instead I have what looks like an artificial 
horizon and tuning list garbled together on the top left corner of the screen. 
Both items are not even checked in the config tool. Panel 1, config screen, and 
the "off" screen work as expected; only Panel 2 has this problem.

There was a similar known issue in MinimOSD-extra that was recently fixed with 
a prerelease firmware update. Perhaps a similar fixe needs to be applied to 
Arducam 2.0.

Original issue reported on code.google.com by imel...@surewest.net on 5 Dec 2012 at 9:47

[GoogleCodeExporter]

Same issue here. Also if I try to load the configuration of Panel 2 back into 
OSD configuration tool, then empty display is loaded.

Original comment by pnikite...@gmail.com on 18 Jan 2013 at 5:21

[GoogleCodeExporter]

Hi,

Try to disable all panels, than save it to osd.
After, enable them, so all variables are rewrote.

Gábor

Original comment by ga...@t-email.hu on 19 Feb 2013 at 3:03

• Changed state: Accepted

[GoogleCodeExporter]

FC APM 2.5 OSD Config 2.1.2.0 Latest firm ware 2.2 and latest char set loaded.
Panels 1 and 2 both display "PM    XXXM" (XXX is some number 6 to 235).I have 
down loaded "empty" screens but the PM remains. 

Original comment by deweoinz...@gmail.com on 28 Mar 2013 at 11:27

[GoogleCodeExporter]

Same issue here.

Original comment by maslows...@gmail.com on 7 May 2013 at 4:29