Sink overflow support - Githubissues

jcallaghan / 3d-printing

I am using this repo to track my research, designs and the things I print.

https://jcallaghan.com/category/journal/3d-printing

0 stars 1 forks source link

Sink overflow support #2

Closed jcallaghan closed 4 years ago

jcallaghan commented 4 years ago

I want to house and secure an Aqara water sensor in my sink over the overflow hole without impeding or block it from functioning as a overflow hole.

jcallaghan commented 4 years ago

More details about the sensor here https://github.com/jcallaghan/home-assistant-config/issues/17

jcallaghan commented 4 years ago

I found a really cool design on Thingiverse which is very close to the design I was going to create. After two test prints, I was able to scale this design for my use-case perfectly.

jcallaghan commented 4 years ago

To track the prints I recorded the XYZ values I used to scale the model so I could get the perfect scale.

Print	X	Y	Z	Result
0	28.97	25.57	16.6	Original.
1	20	17	11	Too small.
2	35	30	20	Too big.
3	27	23	15	Fits although could be deeper.
4	28	25	20	Perfect.

jcallaghan commented 4 years ago