search

jneilliii / OctoPrint-TPLinkSmartplug

105 stars 57 forks source link

temperature failsafe shutting down for too low temp #99

Closed overling closed 5 years ago

overling commented 5 years ago

Running smoothieware and 2 hotend thermistors.

tested failsafe to alarm when temp falls below 5 and tested at 10. Both times it fails with message <5 or <10 and stops print.

set to 0 and printer runs ok.
Temp inside it ambient reading around 24c.

jneilliii commented 5 years ago

@overling, what is your issue/request? Do you want to add the temperature failsafe feature to the plugin so it will automatically turn off the plug when the temperature is below some pre-defined setting? Basically the opposite end of #65?

overling commented 5 years ago

HI, there are two settings, an over temp and an undertemp.

For some reason the undertemp is tripping when its not actually under temp. for example when i set undertemp to stop process <10c and i start the print it will immediately stop the print in alarm. But now i set undertemp setting to 0 and the print will run just fine.
image

This started after updating to the previous octoprint release candidate.

jneilliii commented 5 years ago

My plugin doesn't have those settings, are those in some other plugin you are using to integrate with mine?

overling commented 5 years ago

OH man, i got linked into your git from a thread in another plugin page by accident. Go ahead and close this please. Also, I had to stop using your plugin some months back because it was interfering with another plugin or another plugin was interfering with yours. I had messaged about it but you i don't know if it ever got fixed. I forgot what it was now. anyway sorry for the mix up.