search

jpiat / arduino

112 stars 70 forks source link

Emitter LED #23

Open 4cho opened 7 years ago

4cho commented 7 years ago

Dear Jpiat,

How did you connect wires to the emitter LED and how many arduino mini is need in emitter circuit? I am using the same emitter LED like you but i can't figure out how to connect to the arduino. Actually, I cant see any pin on emitter LED.

jpiat commented 7 years ago

Each code (receiver code and emitter code) has a ASCII drawing on how to connect the led at its top. For the emitter, you'll need one arduino, wired to a led through a current limiting resistor, and for the receiver, another arduino with a led wired to an analog port with a parallel led. Jonathan Piat

Le 24 févr. 2017 6:10 PM, "4cho" notifications@github.com a écrit :

Dear Jpiat,

How did you connect wires to the emitter LED and how many arduino mini is need in emitter circuit? I am using the same emitter LED like you but i can't figure out how to connect to the arduino. Actually, I cant see any pin on emitter LED.

— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/jpiat/arduino/issues/23, or mute the thread https://github.com/notifications/unsubscribe-auth/ACNWZJwJoe1xS4bVHf5Q_Q_4ZTys4pQdks5rfw8IgaJpZM4MLctv .

4cho commented 7 years ago

First of all, thanks for your replay, Jonathan. I saw the ASCII drawing and it is really helpful. For the emitter LED, did u drilled or open the LED to connect the wire inside because I bought the LED which is AC power supply since I can't find another emitter LED like the one you are using.

jpiat commented 7 years ago

You first need to use a plain old 5 or 3mm led dot not start with a LED bulb. To use a LED bulb, i had to make major modifications to it.

2017-02-24 18:28 GMT+01:00 4cho notifications@github.com:

First of all, thanks for your replay, Jonathan. I saw the ASCII drawing and it is really helpful. For the emitter LED, did u drilled or open the LED to connect the wire inside because I bought the LED which is AC power supply since I can't find another emitter LED like the one you are using.

— You are receiving this because you commented. Reply to this email directly, view it on GitHub https://github.com/jpiat/arduino/issues/23#issuecomment-282351423, or mute the thread https://github.com/notifications/unsubscribe-auth/ACNWZKFCy3xHyvqze13QerTCz1gAJ33zks5rfxMngaJpZM4MLctv .

4cho commented 7 years ago

OH... I see. I was trying to figure out how to use that led bulb. :laughing: Thank you for your advise, sir. :+1:

inwan96 commented 6 years ago

@4cho have you found a way to use a led bulb in transmitter ? because my project use a led bulb sir @jpiat

4cho commented 6 years ago

for the time being, I am using such the LED in the link below. http://resource.led-purchase.com/upload/g/20120821/09252241.jpg