search

jsaintrocc / myblvmgncube

These are my notes on building my MGN BLV CoreXY printer. I hope this work helps others in building their own printers.
Other
11 stars 0 forks source link

Missing Y-endstop #10

Closed marutter closed 3 years ago

marutter commented 3 years ago

I just finished assembling my Cube through your step 14. Your instructions have been amazing, thank you.

One thing I think you are missing is the Y endstop (part YEndstop-_FrontLeft-_Rear_left). Not sure if you are going to add that in a later step, or if should be added to step 12 and then adjusted later.

jsaintrocc commented 3 years ago

Thanks @marutter. Good catch! I was debating where to put that but I like your suggestion of putting it in step 12 since it attaches to one of those cross beams. I'm add it once I'm done with my current step which is the cable management and extruder mounting for the hotend.

Regarding the 3d printed piece. Did you need to modify it at all too attach the switch? The holes look really small compared to the limit switch.

Thanks, James

jsaintrocc commented 3 years ago

Did a quick test fit. Looks like M2 12mm screws w/washers will do but the 3d printed mount holes don't line up with switch. Specked as a kw11-3Z which should have 2x m2 holes 9.5mm apart (on center). Part measured is 8.5mm apart (on center). See reference diagram Here. Will need to redesign part with proper hole tolerances.

jsaintrocc commented 3 years ago

See Fysetc's video at 16:18 to see how they did it.

jsaintrocc commented 3 years ago

Ready to go just blocked by heated bed assembly.