search

jshank / bwalink

Automate your Balboa Spa! A docker container with socat and ccutrer/balboa_worldwide_app that supports a remote serial to IP device or host running ser2net, socat or ESPEasy serial server
30 stars 6 forks source link

Initial Start of BWALink is hanging #14

Closed jlogan223 closed 9 months ago

jlogan223 commented 9 months ago

Hi, I have installed the Addon BWALink, updated the config file to have the Bridge IP ( assuming this is the IP for the EW11), left the bridge port as default ( 8899), and not touched any other settings. I then hit save and start the Addon. My Log File just sits like this:


s6-rc: info: service s6rc-oneshot-runner: starting
s6-rc: info: service s6rc-oneshot-runner successfully started
s6-rc: info: service fix-attrs: starting
s6-rc: info: service fix-attrs successfully started
s6-rc: info: service legacy-cont-init: starting
s6-rc: info: service legacy-cont-init successfully started
s6-rc: info: service legacy-services: starting
s6-rc: info: service legacy-services successfully started
[19:00:38] INFO: Starting BWALink addon...
[19:00:38] INFO: Setting addon timezone to Europe/London based on the system timezone.
[19:00:38] INFO: Starting mqtt bridge connecting tcp://192.168.2.13:8899/ to mqtt://core-mosquitto:1883
I,   to spa: #<BWA::Messages::ConfigurationRequest>
D, wrote: 7e 05 0a bf 04 77 7e

Have I done something wrong?

jlogan223 commented 9 months ago

Hi @jshank, Any idea what I could have done wrong? Thanks.

jshank commented 9 months ago

Apologies for the delay @jlogan223 - Did you solve this?

jlogan223 commented 9 months ago

Hi Jim,

No worries. Yes I did thanks. I made the silly assumption that even if the ew11 wasn't connected to the hottub but just powred up, that it would still show up as a stand alone device in MQTT. However, that isn't the case. It needs to be sending some data for it to be picked up by MQTT. Once I connected it to the hottub, it sprang in to life.

This is a great bit of work you have done. Thank you so much. 🙌

From: Jim Shank @.> Sent: Friday, November 10, 2023 9:21:48 PM To: jshank/bwalink @.> Cc: jlogan223 @.>; Mention @.> Subject: Re: [jshank/bwalink] Initial Start of BWALink is hanging (Issue #14)

Apologies for the delay @jlogan223https://github.com/jlogan223 - Did you solve this?

— Reply to this email directly, view it on GitHubhttps://github.com/jshank/bwalink/issues/14#issuecomment-1806450232, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AJDKUOMTJRON47NSVDTVP7LYD2LGZAVCNFSM6AAAAAA7AHC3K6VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTQMBWGQ2TAMRTGI. You are receiving this because you were mentioned.Message ID: @.***>

jshank commented 9 months ago

You bet, thanks for sharing your experience, it helps other who may run into the same issue.