Z Probing not working out of the box after uploading

luc-github / Repetier-Firmware-4-Davinci

Repetier-Firmware-0.92 based for DaVinci printer (Beta - so far so good)

GNU General Public License v3.0

194 stars 99 forks source link

Closed techboycr closed 3 years ago

techboycr commented 3 years ago

I just did a fresh install form the latest git, but for some reason G29 is just not working at all. Always show the error Probe Failed.

Da Vinvi 1.0 with repetier host Compiled from Arduino

Thanks in advance!

luc-github commented 3 years ago

@techboycr sorry just noticed this issue Did you manual bed leveling after flashing as requested in installation steps ?