pakogil
commented
1 year ago It is not physically the same as an MKS DLC32, but internally it is. At least lightburn recognizes it that way, Board Version MKS DLC32 v2.1. This board is made by MKS, I know because the seller of Roly LaserMatic10 told me directly.
El sáb, 12 ago 2023 a las 16:20, Thomas Kroll @.***>) escribió:
But you have recognized that this is NOT a DLC32, right?!
— Reply to this email directly, view it on GitHub https://github.com/makerbase-mks/MKS-DLC32-FIRMWARE/issues/28#issuecomment-1675937430, or unsubscribe https://github.com/notifications/unsubscribe-auth/AKGZ5S5LPC5AUN3OCQKLYHDXU6GMJANCNFSM6AAAAAA3N4ZH5U . You are receiving this because you authored the thread.Message ID: @.***>
nofuturekid
Hello, I have a Roly LaserMatic 10 laser machine that has this control board. I contacted the seller of the machine and he tells me that the plate is made by you. My intention is to use the I2C output to connect a relay and thus take advantage of it to turn the air assistance on and off. Something similar to the schematic attached. I don't know if you have enabled the I2C output on this board. Looking for information, it said that the GPIO22 is the SCL_I2C output, is it correct on this board? When I start Lightburn it tells me that it is a MKS DLC32 v.2.1 firmare V4.00 (8M.H35.20230428).
