MKS GEN_L is a powerful 3D printer control board with ATMEGA2560 and compatible with RAMPS. V2.1 version the motherboard integrates SPI / UART interface and works with MKS TMC2130/TMC2208 V2.0/TMC2209. It can be used after plugged in. No soldering or flying lead is required ...
I'm having issues utilizing E1 for my Z2 stepper. I saw the previous issue with dual Z and added those pin details. Unfortunately M122 reports that Z2 is "All Low". I'm using TMC2208 V3 and the other 4 work as expected but the issue only occurs on E1. I've swapped the driver with another port and it was the same results so I've ruled out a bad driver. Thanks in advance.
I'm having issues utilizing E1 for my Z2 stepper. I saw the previous issue with dual Z and added those pin details. Unfortunately M122 reports that Z2 is "All Low". I'm using TMC2208 V3 and the other 4 work as expected but the issue only occurs on E1. I've swapped the driver with another port and it was the same results so I've ruled out a bad driver. Thanks in advance.