search

makerbase-mks / MKS-Robin

MKS Robin is a powerful 32-bit 3D printer control board with STM32F103ZET6 . Support Marlin2.0. Support MKS Robin TFT24/28/32... Screens. The motherboard integrates 5 AXIS interface, hot bed, 2 heating heads, 3 NTC100K, 2 MAX31855.Support MKS Robin WIFI for cloud printing.Supports firmware update by SD card…
https://es.aliexpress.com/item/32757129463.html?spm=a219c.12010612.8148356.9.5fc165f4oDUfFM
130 stars 129 forks source link

MKS Robin 2 comunication timout when printing over usb cable #100

Open vdc-fx opened 5 years ago

vdc-fx commented 5 years ago

Greetings.

On my Tronxy X5S. I was running standard controller with Octoprint.

After installing the MKS Robin 2. Can print perfectly from the SD card.

From Octoprint and Pronterface. the print will stop with communication timeout.

On Octoprint, the print will continue after a couple of seconds. On Pronterface. the print will stop and does not continue.

The print seems to stop randomly at different points.

Is there a solution to this problem

Thanking you . Vince

vdc-fx commented 5 years ago

Reply from Makerbase

" HI  
If the sd card prints normally, the program on the motherboard should be no problem. If it is printed on usb online, it will be caused by external interference, resulting in abnormal data transmission, so it will stop printing.  
thanks " I have 3 MKS boards.

Old MKS, MKS GenL and MKS Robin2.

Use Raspberry PI and Windows 10 PC

Only the MKS Robin2 has this Fault.

Take it that the USB Ports has some interference during printing.

Will have to use this as a stand alone without PC connection.

github051 commented 4 years ago

For me also same issue with USB printing. SD card work ok. But while printing circles it makes click noise. Dont know what is the issue. I think Makerbase is without testing the boards they will sell. All of their products support is very bad.

vdc-fx commented 4 years ago

Tried Firmware dated 11/01/2019

MKS Robin is working fine now, printing with no problems.

But when I use the latest release. original problem, keeps losing communication.

Still using the old firmware . Hope they can resolve this problem.

I would use another controller, but then I cant use the screen from the Robin 2. (Flat ribbon cable)