search

makerbase-mks / MKS-SERVO42C

MKS SERVO42C, an upgraded version of MKS SERVO42B, built-in Field-Oriented control algorithm, position/speed/ torque closed-loop, 4 Half bridge driver with 8 MOSFET, it makes the motor quieter, lower vibration and Lower calorific.
150 stars 34 forks source link

'Reverse lookup Error' when doing calibeation #64

Open wildblue opened 9 months ago

wildblue commented 9 months ago

What is wrong with my device? I would take a look into the sourcecode (for what GitHub is all about - sourcecodes) myself, but you have first to publish it here.

With the misfittech stepper controller you got this technology for free, please abide by our rules and publish the code of this derived work.

And tell me what's wrong with my device!

Crito02 commented 9 months ago

Just had this issue myself. It should read "hookup" maybe. Try swapping the two middle wires of the lead to the motor. That fixed mine anyway. Good luck

bart-prog commented 3 months ago

solved mine 2 thank u for the help

brooin8 commented 5 days ago

This did not help me. Motor turns both ways during calibration however keeps throwing the error. Hooked up the uart and did a factory reset and still the problem persists. I have also verified that it is reading the magnet on startup. After startup however the readings of the encoder in the uart stay either zero or 220. Never changing as I move the shaft. Not sure what is going on as the motor does spin both ways during calibration. My other 3 work perfect. Faulty board I assume as I swapped the board with 2 different motors and still the same outcome. Motors are working motors Mens 17.