MKS SGEN_L V2.0 is powerful 32-bit 3D printer control board. The CPU is LPC1769 120MHZ, SGEN_L V2 hardware Integrated 4KB EEPROM, 5AXIS and dual Z interface, has 2 way FANs and Dc12/24V out interface, support TMC UART and SPI mode...
Dear Sirs,
I changed mobo and display on my TT PRO, installing MKS SGEN_LV2.0 with TS35 display, 3D touch and TMC2208 V2.0 UART.
Everything is running fine but I have a problem with the one of the 3 fans installed on the hotend.
2 lateral fans are for layer cooling and they are running fine, but the 3rd central fan which is for extruder cooling doesn't start when extruder heats up.
But if I go through display menu and I increase the percentage of fan 2 (which is at 0%) so it starts and then keeps running.
About wiring I copied the connections as for the previous mobo which was MKS SGEN_L V1.0 so maybe I have to do something in the firmware but I don't know what and where.
Please help me, thank you very much!
GROSSO
Dear Sirs, I changed mobo and display on my TT PRO, installing MKS SGEN_LV2.0 with TS35 display, 3D touch and TMC2208 V2.0 UART. Everything is running fine but I have a problem with the one of the 3 fans installed on the hotend. 2 lateral fans are for layer cooling and they are running fine, but the 3rd central fan which is for extruder cooling doesn't start when extruder heats up. But if I go through display menu and I increase the percentage of fan 2 (which is at 0%) so it starts and then keeps running. About wiring I copied the connections as for the previous mobo which was MKS SGEN_L V1.0 so maybe I have to do something in the firmware but I don't know what and where. Please help me, thank you very much! GROSSO