MKS SGEN_L V2.0 is powerful 32-bit 3D printer control board. The CPU is LPC1769 120MHZ, SGEN_L V2 hardware Integrated 4KB EEPROM, 5AXIS and dual Z interface, has 2 way FANs and Dc12/24V out interface, support TMC UART and SPI mode...
So I'm lost, as I really have to put on my jumpers.
My motors are 2A max, I started with 900mv from VRef, but super noisy and vibrate a lot, then I went down from 100mv several times to reach 300mV or the motors no longer work. But at 400mV it's still very noisy. Unsuportable, impossible to leave an impression all night despite the printer is in another closed room.
Hello
So I have the MKS SGEN_L V2 with your TMC2209, but the motors make a lot of noise. Connected in Uart mode I followed your video tutorial HERE: https://www.youtube.com/watch?v=eF8Mqa2Y3oo&ab_channel=MakerbaseTeam
But I found a conflicting video HERE: https://www.youtube.com/watch?v=vSgcH2wjCwY&ab_channel=MakerbaseTeam
So I'm lost, as I really have to put on my jumpers. My motors are 2A max, I started with 900mv from VRef, but super noisy and vibrate a lot, then I went down from 100mv several times to reach 300mV or the motors no longer work. But at 400mV it's still very noisy. Unsuportable, impossible to leave an impression all night despite the printer is in another closed room.
Please Help