Instrument View Rotation In Full 3D Does Not Work If You Draw First

[Matt-Cumber]

The instrument view does not always behave as expected.

Expected behavior

You should be able to rotate the instrument whenever you are on the render tab in full 3D mode

Actual behavior

This is not always the case

Steps to reproduce the behavior

1. Load in a dataset (e.g. MAR11015) and open up Instrument View
2. Check you can rotate the instrument in Full 3D view
3. Now go to the Draw tab and select a different tool that is NOT Navigation (you do not need to draw anything)
4. Go back to the Render Tab and in Full 3D view you should be able to rotate the instrument
5. If you switch the view to something else (e.g. Cylindrical X) then switch back to Full 3D you can no longer rotate the instrument
6. In order to reset this you need to switch tabs and back again

Platforms affected

Found on MacOS, but presumably all

[stale[bot]]

This issue has been automatically marked as stale because it has not had activity in 6 months. It will be closed in 7 days if no further activity occurs. Allowing issues to close as stale helps us filter out issues which can wait for future development time. All issues closed by stale bot act like normal issues; they can be searched for, commented on or reopened at any point. If you'd like a closed stale issue to be considered, feel free to either re-open the issue directly or contact a developer. To extend the lifetime of an issue please comment below, it helps us see that this is still affecting you and you want it fixed in the near-future. Extending the lifetime of an issue may cause the development team to prioritise it over other issues, which may be closed as stale instead.

[stale[bot]]

This issue has been closed automatically. If this still affects you please re-open this issue with a comment or contact us so we can look into resolving it.

[jclarkeSTFC]

Still a problem in 6.10