search

mattlongman / Hassio-Access-Point

Hass.io addon to let you create a WiFi access point, perfect for using WiFi devices on off-grid installations.
MIT License
92 stars 66 forks source link

Unable to start AP #82

Open atrueresistance opened 3 months ago

atrueresistance commented 3 months ago

Hello,

I was trying to get this up and running to keep track of my Bluetti battery in my camper. I followed some directions to get Armbian running on an OrangePi and supervised HA. Any help would be appreciated.

Core 2024.7.4 Supervisor 2024.08.0 Frontend 20240710.0

Hass.io Access Point 0.5.2.1

Starting Hass.io Access Point Addon
# Setup interface:
Add to /etc/network/interfaces: iface wlan0 inet static
Run command: nmcli dev set wlan0 managed no
Warning: nmcli (1.46.2) and NetworkManager (1.42.4) versions don't match. Restarting NetworkManager is advised.
Run command: ip link set wlan0 down
Add to /etc/network/interfaces: address 192.168.99.1
Add to /etc/network/interfaces: netmask 255.255.255.0
Add to /etc/network/interfaces: broadcast 192.168.99.255
Run command: ip link set wlan0 up
# Setup hostapd:
Add to hostapd.conf: ssid=TinyLittleCamper
Add to hostapd.conf: wpa_passphrase=********
Add to hostapd.conf: channel=6
Add to hostapd.conf: ignore_broadcast_ssid=0
Add to hostapd.conf: macaddr_acl=0
Add to hostapd.conf: interface=wlan0
# DHCP enabled. Setup dnsmasq:
Add to dnsmasq.conf: dhcp-range=192.168.99.10,192.168.99.20,12h
Add to dnsmasq.conf: interface=wlan0
Warning: nmcli (1.46.2) and NetworkManager (1.42.4) versions don't match. Restarting NetworkManager is advised.
s6-rc: info: service legacy-services: stopping
s6-rc: info: service legacy-services successfully stopped
s6-rc: info: service legacy-cont-init: stopping
s6-rc: info: service legacy-cont-init successfully stopped
s6-rc: info: service fix-attrs: stopping
s6-rc: info: service fix-attrs successfully stopped
s6-rc: info: service s6rc-oneshot-runner: stopping
s6-rc: info: service s6rc-oneshot-runner successfully stopped
HoLy1337 commented 3 months ago

Hi, I have the same issue, but it only occurs when there was no internet connection available during the boot of Home Assistant. Does your HA instance have internet access when you're trying to start the Access Point? This might help in diagnosing the issue.

Any insights or workarounds would be greatly appreciated.

Thanks in advance!

atrueresistance commented 3 months ago

It did have Internet when starting. I was using eth0 providing LAN access and using the wlan0 for the AP.

atrueresistance commented 3 months ago

I connected a usb wifi adapter and confirmed that armbian can connect via that. Though I was able to connect prior on wlan0

frank@OrangePi:~$ ip link show
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: end0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN mode DEFAULT group default qlen 1000
    link/ether 02:07:46:11:09:f5 brd ff:ff:ff:ff:ff:ff
3: wlx801f027c6e3c: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DORMANT group default qlen 1000
    link/ether 80:1f:02:7c:6e:3c brd ff:ff:ff:ff:ff:ff
4: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state DOWN mode DEFAULT group default qlen 1000
    link/ether 50:d4:e6:88:ff:3a brd ff:ff:ff:ff:ff:ff
5: docker0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DEFAULT group default
    link/ether 02:42:27:76:39:5c brd ff:ff:ff:ff:ff:ff
6: hassio: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DEFAULT group default
    link/ether 02:42:85:d4:39:8d brd ff:ff:ff:ff:ff:ff
8: veth4acef5c@if7: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue master hassio state UP mode DEFAULT group default
    link/ether 82:a3:c0:0b:5b:83 brd ff:ff:ff:ff:ff:ff link-netnsid 0
10: vethbf5c99e@if9: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue master docker0 state UP mode DEFAULT group default
    link/ether 3e:20:fa:b5:e5:03 brd ff:ff:ff:ff:ff:ff link-netnsid 1
12: vethc7cd207@if11: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue master hassio state UP mode DEFAULT group default
    link/ether 66:d7:06:3a:1b:c8 brd ff:ff:ff:ff:ff:ff link-netnsid 1
14: vethcdf47ed@if13: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue master hassio state UP mode DEFAULT group default
    link/ether 5e:8c:05:4b:54:2e brd ff:ff:ff:ff:ff:ff link-netnsid 2
16: vethb75ef14@if15: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue master hassio state UP mode DEFAULT group default
    link/ether 2a:ec:06:cf:bc:c9 brd ff:ff:ff:ff:ff:ff link-netnsid 3
18: veth2d6f894@if17: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue master hassio state UP mode DEFAULT group default
    link/ether 3e:85:1a:97:a6:d5 brd ff:ff:ff:ff:ff:ff link-netnsid 4
24: vethd17f0f3@if23: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue master hassio state UP mode DEFAULT group default
    link/ether 32:56:e8:e2:ac:d3 brd ff:ff:ff:ff:ff:ff link-netnsid 5
frank@OrangePi:~$ nmcli device status
DEVICE                   TYPE      STATE                   CONNECTION
wlx801f027c6e3c          wifi      connected               Supervisor wlx801f027c6e3c
lo                       loopback  connected (externally)  lo
p2p-dev-wlx801f027c6e3c  wifi-p2p  disconnected            --
p2p-dev-wlan0            wifi-p2p  unavailable             --
docker0                  bridge    unmanaged               --
hassio                   bridge    unmanaged               --
end0                     ethernet  unmanaged               --
veth13439f2              ethernet  unmanaged               --
veth2d6f894              ethernet  unmanaged               --
veth4acef5c              ethernet  unmanaged               --
vethb75ef14              ethernet  unmanaged               --
vethbf5c99e              ethernet  unmanaged               --
vethc7cd207              ethernet  unmanaged               --
vethcdf47ed              ethernet  unmanaged               --
wlan0                    wifi      unmanaged               --
frank@OrangePi:~$ nmcli connection show
NAME                        UUID                                  TYPE      DEVICE
Supervisor wlx801f027c6e3c  0866fea1-86e2-4c54-8955-3b597d943258  wifi      wlx801f027c6e3c
lo                          35071640-e174-4afd-ac26-8b32dcd00641  loopback  lo
atrueresistance commented 3 months ago

So oddly enough if I leave wlan0 alone and use a usb dongle I can connect no problem. image