Open GoogleCodeExporter opened 8 years ago
I have downloaded version 12 and re-compiled.
I then ran ./smatool -d and I have attached the output in a TXT file.
This was run in a putty session. I hope this helps?
Original comment by masd...@gmail.com
on 9 May 2011 at 5:21
Attachments:
Hi,
are you sure your inverter password is OK? I had a similar problem - See defect
18
Original comment by luc.van....@skynet.be
on 9 May 2011 at 9:00
thanks for the info Luc, I will try this tomorrow. is there a problem using tab
to seperate the 1111 from password.
is someone able to post the single line from smatool.conf so I have a better
idea of what it is meant to look like.
Original comment by masd...@gmail.com
on 9 May 2011 at 3:15
tabs are ok, but I think you need user password (0000 by default) not the
installer password
Original comment by luc.van....@skynet.be
on 10 May 2011 at 8:21
Okay, Update. I downloaded and configured SMATOOL 0.12 before going on holidays.
I changed the password to 0000 and it seems to be working now.
Now I have to figure out how to setup and configure MYSQL.
Original comment by masd...@gmail.com
on 26 Jun 2011 at 10:22
Original issue reported on code.google.com by
masd...@gmail.com
on 3 May 2011 at 11:04Attachments: