What steps will reproduce the problem?
1.Direct Serial Connection to TS940S
2.COM5 - 4800 BAUD - Parity none - Data 8 - Stop 1
3.Rig is switched from A SSB to CW, software recognizes the switch to CWU, and
choses correct mode CWU. I slick on set up IF to calibrate the CWU Frequency.
it is greyed out..cannot adjust. So I manually go to CWL in software.. and
Ihave it close.. but obviously it tunes in reverse.
What is the expected output? CWU Not greyed out when clicking Setup IF>IF
Frequencies
What do you see instead? CWU IS Greyed out when clicking Setup IF> IF
Frequencies
What version of the product are you using?1.19.3.5
On what operating system? Win 7 Ultimate 64 Bit
Please provide any additional information below.
FSKU is also greyed out.. im not sure if that would be an issue or not. But the
CWU is a definate issue.
Original issue reported on code.google.com by sjr...@gmail.com on 13 Jan 2012 at 6:53
Original issue reported on code.google.com by
sjr...@gmail.comon 13 Jan 2012 at 6:53