search

protoloft / klipper_z_calibration

Klipper plugin for self-calibrating z-offset
GNU General Public License v3.0
1.06k stars 152 forks source link

Z hight for XY-move before probe-switch probing #72

Closed onkel-serg closed 2 years ago

onkel-serg commented 2 years ago

Since update the Z-calibration doesn't work properly. The switch-pin of microswitch, that I use for Klicky probe is longer, that one of D2F-5. That causes no any problems on my V2.4 before update. Currently, after nozzle probing the Klicky probe will be attached and printhead moves down to some (which?) z height. After that, Printhead performs XY-move to z-endstop position, at this point the microswitch-pin hits the z-endstop pin from the side. So, for my setup Klicky must be higher before moving to z-endstop position, or first perform XY-move and then lower the Klicky down. How can I change this?

onkel-serg commented 2 years ago

solved by setting clearance: 20 in z_calibration.cfg