No picture visible on PRUSA Connect... WHY?

[HydroLuz]

Hello everybody,

I have carefully followed the instructions for the Freenove ESP32-WROVER and succesfully connected it to PRUSA Connect. Snapshots are constantly being send to PRUSA Connect, but I cannot see anything..

Does anyone know why?

I have tested the camera with the Arduino sketch provided by Freenove and it works. However, with on PRUSA Connect I only see a black image...

Any solutions? I would be very grateful :)

[johnyHV]

Hello @HydroLuz . Do you still have the same problem?

[HydroLuz]

Hello @HydroLuz . Do you still have the same problem?

@johnyHV unfortunately I do... I have tried out the arduino sketch aswell, however I also just see black images even though it appears to send pictures to Prusa Connect.. Now I have tested the arduino sketch provided by Freenove again and it shows me footage (see picture). I really understand what is the problem...

[HydroLuz]

Hello @HydroLuz . Do you still have the same problem?

@johnyHV unfortunately I do... I have tried out the arduino sketch aswell, however I also just see black images even though it appears to send pictures to Prusa Connect.. Now I have tested the arduino sketch provided by Freenove again and it shows me footage (see picture). I really understand what is the problem...

Here you can see that the camera is registered with Prusa Connect:

[HydroLuz]

Hello @HydroLuz . Do you still have the same problem?

Here you can see the Wifi connection status: and here the System status:

[johnyHV]

@HydroLuz Strange. Please, can you send me board picture ? From both side. Thanks

[HydroLuz]

@HydroLuz Strange. Please, can you send me board picture ? From both side. Thanks