search

prusa3d / PrusaSlicer

G-code generator for 3D printers (RepRap, Makerbot, Ultimaker etc.)
https://www.prusa3d.com/prusaslicer/
GNU Affero General Public License v3.0
7.79k stars 1.94k forks source link

Mapping a bad part of the heated bed? #4431

Closed FlailAway closed 4 years ago

FlailAway commented 4 years ago

Version

2.2.1

Operating system type + version

Any

3D printer brand / version + firmware version (if known)

Any

Behavior

Not PrusaSlicer's fault, but I have a small bulge (about US-Penny size) in the buildtak and I have to remember to always position the part to be printed away from, or with a hole over that spot. I do not want to replace the buildtak just for the small issue.

Is there a (or can we have) way to map-out a portion of the bed so when it plonks down a part, it is not right over the center of the damaged Delta bed.

rtyr commented 4 years ago

Duplicate of https://github.com/prusa3d/PrusaSlicer/issues/3866.

Simple way to avoid such place on the bed is to use custom bed texture (can be set in printer settings).

4431

Closing. You can continue discussion here https://github.com/prusa3d/PrusaSlicer/issues/3866.