Closed raspberrypi321 closed 6 years ago
Also a joypad board will be used for controller in put
Closing thread, as this is not an issue. As long as it does not include RetrOrangePi (because of noncommercial retropie content), it should be OK. Check our forums for discussions : Forum: http://orangepi.club/forumdisplay.php?fid=5 Facebook group: https://www.facebook.com/groups/1131759626884432/
I Am doing a Project .
Components are as follows:
Orange pi PC 4000mah li ion Class 10 card x 2 3.7v to 5v 1 A and 2A powerbank Main Board {for charging and output} 64gb USB
Softwares need to be run:
Retrorange pi Android
It will most likely be in a custom 3d printed case.
For heat Removal, OPi will be placed flipped so its ram and processor will be facing down.A copper heating will be attached.
I am trying to place it in a flipflop shape {like Nintendo 3Ds} and Ports at the back {hdmi usb etc}
For screen i will use 5 inch waveshare screen.but gpio headers or mounts will be cut off or desoldered to reduce bulk.
They only purpose of this is retro and some what android gaming.!!PORTABLE!!