How to build firmware ?

[quadrant2005]

Please can you advise on how to build the firmware under windows 7 what tools are needed etc, Or please can you provide a project to get up and running with building this firmware etc please, Im a C programer but have not worked with this chip before, I normally use Eclipse when programing Arm Cortex STM32F427VIT6 MCU, i have downloaded and installed ST Visual Developer and ST Visual Programmer. If anyone can help to get up and running that would be much apprecaited. Thank you. regards Richard quadrant@teamrobotics.co.uk

[semerad]

Some info is in README.internal file:

• for windows there is "compile.bat", but I didn't used it (one man reported there is problem when path to C compiler contains spaces)
• I was building it at linux using Makefile and running Cosmic C compiler via wine

[rosiesde]

I have used the software for GT3B and GT3C. Everything runs great. But the switch of channel 3 works only in Edit Mode / End Point. If you leave the set mode, the switching of channel 3 does not work. I have tested the versions 06.2, 0.6.1, 0.6.0, 0.5.1, 0.5.0. All versions have the same probelem with channel 3. No switching function at Chanel 3.

rosies_de@stcb.de

I must correct myself. I have now found the function for button 3 / channel 3 after all. There are so many functions in the firmware that it took a few days until I understood all the functions. Once again a big apology. The software has much more than I will ever use. Thanks a lot for that.

rosies_de@stcb.de