Failed to associate with BSSID , i know what im doing , but please help

[GoogleCodeExporter]

Answer the following questions for every issue submitted:

0. What version of Reaver are you using?  (Only defects against the latest
version will be considered.)
 version 1.4 comes attached to backtrack

1. What operating system are you using (Linux is the only supported OS)?
BacktrackR2  i believe

2. Is your wireless card in monitor mode (yes/no)?
for sure it was  (mon0)

3. What is the signal strength of the Access Point you are trying to crack?
airodump shows -59 , around there nothing higher than -70

4. What is the manufacturer and model # of the device you are trying to
crack?
the router is for sure a linksys E1000  

5. What is the entire command line string you are supplying to reaver?
reaver -i mon0 -b BSSID -vv   ( sometimes i try to add --dh-small)

6. Please describe what you think the issue is.
i have no clue , it just fails to associate with the only bssid wash can pick 
up on my laptop

7. Paste the output from Reaver below.

[!} WARNING: Failed to associate with BSSID (ESSID: ESSID)

i have tried wash , wash shows the BSSID:  channel 1 , RSSI -58  WPS VERSION: 
1.0   WPS Locked: No  

its not supposed to be wps locked right ? if so then whats the problem ?

if it helps , this router , has 2 AP's  one of them being a guest AP 

Original issue reported on code.google.com by Sneakygu...@gmail.com on 14 Dec 2012 at 2:09

[GoogleCodeExporter]

ALSO , i have cracked this router before , password has changed , a guest AP 
has been added , and now it wont even associate 

Original comment by Sneakygu...@gmail.com on 14 Dec 2012 at 2:11

[GoogleCodeExporter]

ALSO  , encryption is WPA2 , CIPHER is CCMP , and AUTHENTICATION is PSK

Original comment by Sneakygu...@gmail.com on 14 Dec 2012 at 2:12