[ y] I read the README (on master) thoroughly
[ y] I run the your's MAX30100_Heart_Beat_Serial.ino
and I'm going to paste the output down below
[y] I filled in all the details of my setup down below
Description of the issue
1.RD pin get lighten when it goes to the GND alone.connection is -
NANO --> MAX30100
SDA --> SDA
SCL --> SCL
INT --> Not connected
IRD --> Not connected
RD --> GND
input-5v with pullup of 4.7k ohm to the SDA & SCL
and visual connection is-
Even I tried with 10k ohm same issue is happening.
2.Both RD and IRD connect with GND,due to this the RED light doesn't got lighten.The connection is-
NANO --> MAX30100
SDA --> SDA
SCL --> SCL
INT --> Not connected
IRD --> GND
RD --> GND
When the RED led on(according to the 1st connection) and I am placing the finger on it but doesn't happen any thing it still shows no reading.
Please Try to resolve the issue.....
Troubleshooting checklist
[ y] I read the README (on master) thoroughly [ y] I run the your's MAX30100_Heart_Beat_Serial.ino and I'm going to paste the output down below [y] I filled in all the details of my setup down below Description of the issue
1.RD pin get lighten when it goes to the GND alone.connection is - NANO --> MAX30100 SDA --> SDA SCL --> SCL INT --> Not connected IRD --> Not connected RD --> GND input-5v with pullup of 4.7k ohm to the SDA & SCL and visual connection is-
Even I tried with 10k ohm same issue is happening.
2.Both RD and IRD connect with GND,due to this the RED light doesn't got lighten.The connection is- NANO --> MAX30100 SDA --> SDA SCL --> SCL INT --> Not connected IRD --> GND RD --> GND
Input-5v with4.7k ohm pullup to get function.
Arduino hardware: Nano MAX30100 breakout: MAX30100 Arduino framework version: Arduino v1.6.12 MAX30100 library version: your lib.
When the RED led on(according to the 1st connection) and I am placing the finger on it but doesn't happen any thing it still shows no reading. Please Try to resolve the issue.....