Open mpikzink opened 6 months ago
Please try if it is fixed in 0.30.1
Please try if it is fixed in 0.30.1
Unfortunately, the behavior has not changed with 0.30.1.
Unfortunately, the behavior has not changed with 0.30.1.
Thank you for testing that - we fixed the prompt for others procurve models in 0.30.1
I also suspect a prompt issue here.
Sure, I will post a cleaned output ASAP. I also see that after the upgrade some HP devices breaks with a regex mismatch which was running before but I haven't digged deeper yet.
For this switch type the output under ~/.config/oxidized/logs/(device-ip)-ssh is empty.
OK, thanks. I'll have a look at it, I just need time to orginise an Access to a 2620.
Got today access to a 2620-24, fetching the configuration worked without tuning:
! Image stamp: /sw/code/build/xform(RA_15_05)
! Aug 9 2011 09:08:18
! RA.15.05.0006
! 44
! Boot Image: Primary
!
! No Transceiver found on any selected port.
! Image Size (bytes) Date Version
! ----------------- ------------ -------- --------------------
! Primary Image : 8829329 08/09/11 RA.15.05.0006
! Secondary Image : 8829329 08/09/11 RA.15.05.0006
!
! Boot ROM Version : RA.15.10
! Default Boot : Primary
!
!
! Status and Counters - General System Information
!
! System Name : HP-E2620-24
! System Contact :
! System Location :
!
! MAC Age Time (sec) : 300
!
! Time Zone : 0
! Daylight Time Rule : None
!
!
! Software revision : RA.15.05.0006 Base MAC Addr : 24be05-******
! ROM Version : RA.15.10 Serial Number : ********
! Allow V1 Modules : Yes
!
!
!
Running configuration:
; J9623A Configuration Editor; Created on release #RA.15.05.0006
; Ver #01:01:00
hostname "HP-E2620-24"
vlan 1
name "DEFAULT_VLAN"
untagged 1-28
ip address dhcp-bootp
exit
snmp-server community "public" unrestricted
no dhcp config-file-update
password manager
password operator
Thank you for this information. I have checked the devices in our setup, the oldest software version on our environment is RA.15.08.0009. So I will try to downgrade. And we auth with priv/public key to our switches, so even it has something to do with one of them.
We have an problem with the HP Procurve 2620 series, other series of Procurve/Aruba do not have this problem. It is a reproducible problem on a total of 15 devices in our infrastructure of the same model with different equipment types (POE/PortCount) and firmware versions. If you try to connect via SSH, the connection is established successfully. Oxidized also gets a prompt, which can be seen in the debug output, but immediately afterwards the connection is closed with the raise condition
Net::SSH::Disconnect with msg "connection closed by remote host"
.The option
ssh_no_keepalive: true
also had no effect. Do you have any other tips on how we can continue debugging?