PEv2 / PoExtBusOC16CNC - Axis Enable-Out not set.

zarfld / LinuxCnc_PokeysLibComp

Pokeys comp for LinuxCnc using https://bitbucket.org/mbosnak/pokeyslib.git

MIT License

5 stars 0 forks source link

PEv2 / PoExtBusOC16CNC - Axis Enable-Out not set. #2

Closed zarfld closed 2 years ago

zarfld commented 2 years ago

Pin 1 is assinged according to PoExtBusOC16CNC-Manual. even if this Output set manually AxisEnable Signal is not set at drivers. (inverting output does not help either)

zarfld commented 2 years ago

try to use external 5V supply instead/in addition of 5V supply of Pokeys57E

zarfld commented 2 years ago

For ALL connected Axes the AxisEnabledPin was Set to 1 & unchecked "invert axis enabled". 5V supply added -> StepperDrivers are being switched on in State: 3"Running" and Switched of in "Stop"