search

0xD34D / ender3-v3-se-klipper-config

Klipper config for the Ender-3 V3 SE
108 stars 14 forks source link

Insufficient extrusion at the beginning of printing. #14

Open Alexandrinn opened 7 months ago

Alexandrinn commented 7 months ago

Are there settings in the configuration that affect the extrusion at the start of the print after each move? In the slicer, retracts are 0, in gcode there are also no retracts, but after each movement of the nozzle there is an insufficient extrusion of 5-7 mm.

Arian04 commented 7 months ago

pressure advance, but that's not in the files unless you added it. extra restart distance or extra prime amount after retraction or something along those lines (in your slicer) would do the same if it was a negative value.